The interfacial dilational properties of hydrophobically modified associating polyacrylamide studied by the interfacial tension relaxation method at an oil-water interface

The interfacial dilational viscoelastic properties of hydrophobically associating block copolymer composed of acrylamide (AM) and a low amount of 2-phenoxylethyl acrylate (POEA) (<1.0 mol%) at the octane-water interfaces were studied by means of the interfacial tension relaxation method. The dependencies of interfacial dilational elasticity and viscous component on the dilational frequency were investigated. The interaction of hydrophobically associating block copolymer [P(AM/POEA)] with sodium dodecyl sulfate (SDS) has been explored. The results show that at lower frequency, the dilational elasticity for different concentration copolymer is close to zero; at higher frequency, the dilational elasticity shows no change with increased frequency; At moderate frequency (10(-3)-1 Hz), the dilational elasticity decreased with a decrease in the dilational frequency. The results show that the hydrophobic groups of [P(AM/POEA)] chains can be associated by inter- or intrachain liaisons in water solution. The dilational viscous component for P(AM/POEA) comes forth a different maximum value at different frequencies when the polymer concentration is different. It is generally believed that the dilational viscous component reflects the summation of the various microscopic relaxation processes at and near the interface and different relaxation processes have different characteristic frequencies. The spectrum of dilational viscous component may appear more than once maximum values at different frequencies. The influence of SDS on the limiting dilational elasticity and viscous component for polymer solution was elucidated. For 5000 ppm polymer solution, the limiting dilational elasticity decreased with an increase in SDS concentration. The dilational viscous component passed through a maximum value with a rise in the dilational frequency, which appeared at different frequency when SDS concentration is different; and the higher is the concentration, the lower is the dilational frequency. It can be explained that macromolecules may be substituted by SDS molecules in the interface and the interaction of molecules decrease, which makes the limiting dilational elasticity decrease. For 200 ppm polymer solution, the limiting dilational elasticity increased firstly and then decreased with SDS concentration increasing. This may be explained that the interfacial polymer concentration is so low that SDS molecules absorbed in the interface dominate dilational properties of the interfacial film even at very low SDS concentration. However, SDS molecules can gradually substitute the polymer molecules in the interface with a rise in SDS concentration, which results in the decrease in the limiting dilational elasticity.     

Pt/Al2O3蜂窝状催化剂上NO选择性催化还原反应动力学研究

采用多次涂层和浸渍法制备了蜂窝状Pt/Al2O3催化剂，并在高空速和大气体流量条件下对无梯度循环式反应器和积分反应器上催化剂的活性进行了比较。同时采用循环式反应器对动力学数据进行了测定。根据Langmuir-Hinshelwood模型和实验结果，推测了NO-C3H6-O2体系的SCR反应机理，并导出了NO和C3H6反应速率的数学表达式。据此所计算的理论模拟值能够与实验值很好地吻合。实验结果表明，氧气浓度对NO和C3H6的反应速率有明显的影响，二者均随着氧浓度c (O2)的增加达到峰值，再增加氧气浓度时，C3H6的反应速率r(C3H6)保持不变，而NO反应速率r (NO)却下降，而且下降的程度随着温度的升高而加剧。同时，随着氧气浓度增加，r (NO)达到最大值时的温度亦随之下降。     

静电纺丝法制备硫酸化的二氧化锆/二氧化硅复合纤维

将电纺丝技术与溶胶-凝胶技术相结合, 制备了SZ粒子分布于SiO2纤维外壁的硫酸化的二氧化锆/二氧化硅复合纤维. 与常见的SZ复合催化剂相比, 采用SiO2纤维负载SZ不仅可以解决粉体材料带来的难以与反应体系分离等弊病, 同时功能粒子SZ分布与纤维外壁的结构也提高了功能粒子的利用率.     

室温熔盐二(三氟甲基磺酸酰)亚胺锂-尿素体系的分子动力学模拟

应用分子动力学模拟了25 ℃和50 ℃时新型室温熔盐二(三氟甲基磺酸酰)亚胺锂[LiN(SO2CF3)2, LiTFSI]与尿素(摩尔比为1:3.6)体系的结构与动力学性质. 在两个温度下体系的微观结构基本相同, Li+的配位数约为5, 且都是与溶剂和阴离子中的氧原子发生配位. 对TFSI-的研究表明, 每个TFSI-只提供四个氧中的一个与Li+配位; 而且在Li+的配位层中, TFSI-具有顺、反和gauche 等不同的构象, 并且不同构象出现的几率会随着温度的改变而改变.     

Li_3PO_4包覆LiMn_2O_4正极材料的结构表征和电化学性能

采用共沉淀法在尖晶石LiMn2O4颗粒表面包覆Li3PO4.XRD、SEM研究结果表明,包覆后的材料仍为尖晶石结构,粒径均匀.电化学性能测试表明,Li3PO4包覆层的存在,减少了正极材料与电解液的直接接触,抑制了高温下电解液对LiMn2O4材料的侵蚀,从而有效改善了高温下材料的循环性能.在40℃时,包覆样品的比容量衰减率都低于未包覆样品,其中包覆1%Li3PO4的样品的初始比容量为110.4mAh/g,50次循环后比容量为84.1mAh/g.     

Synthesis and Structural Characterization of 1,4-Di（2-methoxyphenyl）-2,5-piperazinedione

A new derivative of 2,5-piperazinedione, 1,4-di（2-methoxyphenyl）-2,5-piperazinedione （I）, was synthesized by the cyclocondensation reaction of N-2-methoxyphenyl chloroacetamide, and its structure was characterized by elemental analysis, IR, ^1H NMR and single crystal X-ray diffraction method. The crystal belongs to monoclinic system, space group P21/c with unit cell dimensions a=0.56934（10） nm, b=1.3880（2） nm, c=1.00329（17） nm, β= 90.376（3）°, V= 0.7928（2） nm^3, Z=2, Dc = 1.367 g·cm^-3,μ = 0.98 cm^-1, R and wR being 0.0606 and 0.1564 respectively for 1549 unique reflections with 1247 observed reflections [I〉2σ（I）]. The molecule has a crystallographically imposed symmetry center. The three rings in the molecule are each coplanar with their attached groups, excluding methyl H atoms and the H atoms attached to the piperazinedione ring, while the whole molecule is not planar, with dihedral angles of 74.7（1）° between the piperazinedione and each of the two aromatic rings. The crystal structure is stabilized by van der Waals and dipole-dipole forces.     

脑蛋白水解物中氨基酸的柱前衍生高效液相色谱测定

通过升高色谱柱温度,结合线性梯度洗脱的分离模式调整色谱分离的选择性,提出了一种测定脑蛋白水解物注射液中氨基酸含量的2,4-二硝基氟苯(DNFB)柱前衍生高效液相色谱方法。本法采用Kromasil C18(250×4.6 mm i.d.,5μm)色谱柱,柱温44℃,在30 min内以3个线性梯度能完全分离17种氨基酸,定量线性范围为0.2~1.0mg/L;加标回收率为89%~108%。该法具有适用性好、稳定性高等特点,也可以应用于其它种类样品中氨基酸的测定。     

桑蚕丝素蛋白初始结构对其矿化作用的影响

以碱金属离子诱导桑蚕丝素蛋白溶液发生构象转变, 研究了蛋白质初始结构对其矿化作用的影响. FT-IR, XRD和SEM等测试结果显示, 未经任何处理的桑蚕丝素蛋白溶液矿化后形成片状复合物, 其无机相以二水磷酸氢钙(DCPD)为主; 而经过K^＋和Na^＋金属离子处理后, 桑蚕丝素溶液的结构由无规线团/螺旋构象向β-折叠发生转变, 矿化后成纤维状, 并相互结合呈现纳米级的三维多孔结构, 其无机相以热力学稳定的羟基磷灰石(HA)为主. 可以认为, 丝素蛋白结构转化为较伸展的β-折叠后, 使得更多的亲水基团暴露在外面, 在丝素蛋白分子不断凝聚成纤过程中, HA结晶快速生长并附着在这些微纤上, 最终形成纤维状的丝素蛋白/HA复合物. 该结果为阐明蛋白质的生物矿化过程及其调控机理提供了理论依据, 同时可以从矿化复合物的形成来反映这些微量元素可能对骨组织形成的影响, 为临床骨组织的修复提供一定的参考.     

有机阴离子柱撑水滑石催化酯交换合成碳酸二苯酯

 A series of organic anion-pillared hydrotalcites were synthesized by the ion exchange method and characterized by X-ray diffraction and Fourier transform infrared spectroscopy. The hydrotalcite precursor and pillared hydrotalcites with different anions was tested as catalysts in transesterification of dimethyl carbonate (DMC) with phenol. The results show that the catalytic selectivity of this transesterification reaction over these organic anion-pillared hydrotalcites is significantly improved. The catalytic selectivities of C4H4O4-, C6H8O4-, C10H16O4-, 1,4-C8H4O4-, and C7H5O2-pillared hydrotalcites for transesterified products (diphenyl carbonate and methyl phenyl carbonate) are all greater than 90%, at least 10% higher than that of the hydrotalcite precursor. Under the conditions of n(phenol)/n(DMC)=4, catalyst amount=1.5%, and t=10 h, the C6H8O4-pillared hydrotalcite presents the best catalytic performance, and the DMC conversion and the selectivity for transesterified products reach 43.8% and 93.2%, respectively.     

反应条件对Cu/Al-Ce-PILC上丙烯选择性催化还原NO反应的影响

 采用聚合羟基复合阳离子合成交联黏土Al-Ce-PILC, 经SO2-4改性后,以浸渍法制备了铜基交联黏土催化剂Cu/Al-Ce-PILC, 并将其应用于C3H6选择性还原NO的反应,考察了预处理气氛、 O2和C3H6浓度、空速、水蒸气和SO2等反应条件对催化剂性能的影响. 结果表明, He预处理后催化剂表面的Cu物种以Cu+和Cu2+两种形式存在,而H2预处理后仅以Cu+存在, NO转化率最大值由23%升至56%. 反应体系中适当的O2和C3H6浓度可促进NO还原为N2, 但过高的浓度反而可降低NO的还原活性, O2同时可起到抑制积炭、清洁催化剂表面的作用. NO转化率随着空速的增大而降低. 10%水蒸气的存在可抑制NO的还原和C3H6的氧化,其转化率曲线向高温方向位移. 但是,由于金属氧化物交联柱表面的疏水特性, Cu/Al-Ce-PILC较Cu/ZSM-5具有较强的耐湿热稳定性, NO和C3H6最大转化率仅分别下降13%和5%. SO2的存在明显抑制了催化剂的低温活性,但对高温活性有一定促进作用.